How2Power.com
Answering your Questions about Power Design  

HOW2POWER ARTICLES — 2011


    December
  • Current-Loop Control In Switching Converters Part 4: Clarifications Of Existing Models
  • Power Electronic Circuitry In LED Modules: An Overview
  • Measuring the Cross Regulation Of Dual Output DC-DC Power Converters
  • PV Systems And Inverter Engineering Teams Are Scaling Up
  • Operation of a New Half-Bridge Gate Driver for Enhancement-Mode GaN FETs, Type LM5113, Over a Wide Temperature Range
      • November
  • Core Geometry Coefficient For Resonant Inductors
  • Current-Loop Control in Switching Converters Part 3: Waveform-Based Model Dynamics
  • Self-Starting Can Be Hard To Do–Understanding Power-On-Reset Requirements In Regulators And Bandgaps
  • Use Intelligent High-Side Power Switch To Satisfy Safety Requirements In Process Control And Industrial Automation
  • Power Design Remains Core Competence in Satellite Industry
  • New Hardware-in-the-Loop Platform for Rapid Development of High-Reliability EV and HEV Propulsion Drives
  • Understand and reduce DC/DC switching-converter ground noise
      • October
  • Ultrasound Poses Ultimate Test of Low-Noise Design Skills
  • Use Exponential Equations And A Simple Program To Solve Power Supply Problems
  • Current-Loop Control In Switching Converters Part 2: A Waveform-Based Model
  • A Holistic Approach To Reducing Backlight Power Consumption
  • Solar charging solution provides narrow-voltage DC/DC system bus for multicell-battery applications
  • Surviving Load Dumps On Military Vehicles
      • September
  • How2 Get From AC To Below 1 V With eGaN FETs
  • Current-Loop Control In Switching Converters Part 1: Historical Overview
  • Circuit Implements Low-Cost Ballast Control With High Power Factor
  • PaytonTechV1Review: Benefits of Planar Magnetics
  • Stability Analysis of Power Supplies with the Bode 100
  • New Technique for Non-Invasive Testing of Regulator Stability
      • August
  • Designing Power Converters For 100°C+ Environments: Why Use 225°C-Rated Power Components?
  • Component Aging Is Primary Hurdle In Design Of High-Temperature Power Converters
  • Aspiring Power Electronics Engineers Must Master Four Aspects Of Converter Design
  • Aspiring Power Electronics Engineers Must Master Four Aspects Of Converter Design
  • EV Charging Stations: A New Outlet for Power Designers
  • A Simple Method to Determine ESR Requirements for Stable Regulators
  • Design for Life, The pitfalls of reliable power supply design
  • Power Electronics Engineers Move EVs And Hybrids Forward With Cost-Cutting Innovations
      • July
  • How To Implement A 5-W Wireless Power System
  • Why Use Aluminum Wire?
  • Quad-Comparator Circuit Provides Power-Down Sequencing At Low Cost
      • June
  • Add A Black Box To Your Big (Or Small) Box
  • Tapped Inductors Enable Simple, Compact Buck-Boost Converters With Single Noninverting Or Dual, Complementary Outputs
  • Solar Microconverter Implements Novel MPPT Algorithm
  • Wind Turbine Makers Turn to Power Electronics Engineers for Robust Solution
  • The Sine Amplitude Converter Topology Provides Superior Efficiency and Power Density in Intermediate Bus Architecture Applications
  • Power Electronics Engineers Can Build Diverse Project Portfolio In EMS Industry
      • May
  • MOSFET Package Technology Enhances Performance Of Motor Drives
  • Simple Stepdown Regulator Generates Multiple Voltage Rails With Good Efficiency and Regulation
  • Eliminate The Guesswork When Selecting Primary Switch VDD Capacitors
  • Energy Meter Design Operates Accurately Over Wide Current Range
  • GaN Transistors Make Inroads Commercially While Technology Expands To Higher Voltages
  • The Promise of Solid-State Lighting Depends On the Prowess of Power Electronics Engineers
  • Digital Power Control Impacts Power Design on Many Levels (Part 2)
  • XRP77XX: Extending the MOSFET Gate Drive Conductors
      • April
  • The Magic Carpet Ride: Class D Audio Circuit Design And Some Live Testing Results
  • An Accurate Method For Measuring Capacitor ESL
  • Single-Stage Flyback LED Driver Meets Class C Limits on Harmonic Currents
  • Emerging High-Voltage Apps Accelerate Silicon Carbide Growth
  • Rap Session Wrap Up: APEC Panelists Explore Social Media As Cure For Corporate Hiring Woes
      • March
  • Match Circuit And Field Resistances For Optimal Magnetics Design
  • Adjustable Clamp Circuit Enables Use of Lower-Voltage MOSFET In High-Voltage Flybacks
  • Paralleling Electrolytic and Ceramic Capacitors Perks Up POL Transient Response
  • Digital Power Control Impacts Power Design on Many Levels (Part 1)
  • Power Supply Measurement Techniques Using Picotest Signal Injectors
  • HP Employs Multiple Disciplines and Collaborative Approach To Optimize Power Utilization Across The Data Center
      • February
  • Utilizing Full Saturation and Power Loss To Maximize Power Transfer In Magnetic Components
  • Primary-Side Current Monitoring Won’t Stop Overcurrents In DCM-Operated Flybacks
      • January
  • The Over-Power Phenomenon in DCM/CCM-Operated Flyback Converters (Part 4): The Leakage Inductor Contribution
  • Synergy: SEPIC-Cuk Combo Illustrates Benefits of Creative Thinking
  • Tale of the Bode Plot Failure
  • Automotive LED Driver Keeps Backlights Running Under Cold Cranking
  • Emerging Applications Need Energy-Saving Design Skills Most
  • Forecasted Growth For Wind Power May Whip Up Demand for PE Engineers

    •    
       
       
       
       
    About | Design Guide | Newsletter | SiC & GaN | Power Magnetics | Power Links | Events | Careers | Bookstore | Consultants | Contacts | Home | Sitemap   
    This site is protected by copyright laws under U.S. and international law. All rights reserved.